Acura 2007 RDX Owner's Manual page 81

Table of Contents
Main Menu
To reset a trip meter, display it, and
then press and hold the Select/Reset
knob until the number resets to ''0.0''.
When you reset Trip A, AVG. FUEL
A is reset at the same time. When
you reset Trip B, AVG. FUEL B is
reset.
AVG. FUEL A/B
This shows your vehicle's average
fuel economy in mpg (U.S. models)
or /100 km (Canadian models)
since you last reset the Trip A or
Trip B.
The average fuel mileage will be
reset when you reset the trip meter,
or if the vehicle's battery goes dead
or is disconnected.
Outside Temperature Indicator
This shows the outside temperature
in Fahrenheit (U.S. models), or in
Centigrade (Canadian models).
The temperature sensor is in the
front bumper. The temperature
reading can be affected by heat
reflection from the road surface,
engine heat, and the exhaust from
surrounding traffic. This can cause
an incorrect temperature reading
when your vehicle speed is under
19 mph (30 km/h). When you start
your trip, the sensor is not fully
acclimatized, therefore it may take
several minutes until the proper
temperature is displayed.
In certain weather conditions,
temperature readings near freezing
(32°F, 0°C) could mean that ice is
forming on the road surface.
If the outside temperature is
incorrectly displayed, you can adjust
it up 5°F in U.S. models ( 3°C in
Canadian models) warmer or cooler.
NOTE: The temperature must be
stabilized before doing this
procedure.
To adjust the outside temperature
indicator, press and hold the Select/
Reset knob for 10 seconds. The
following sequence will appear for 1
second each: 0, 1, 2, 3, 4, 5,
3, 2, 1, 0 (U.S.) or 0, 1, 2, 3,
3, 2, 1, 0 (Canada).
When the temperature reaches the
desired value, release the Select/
Reset knob. You should see the new
outside temperature displayed.
Gauges
5, 4,
CONTINUED
77