Acura 2007 RDX Owner's Manual page 373

Main Menu
Table of Contents
BLADE
3. Remove the blade from the blade
assembly:
Find two tabs with a ''SET'' and
'' '' mark on the wiper blade
assembly. The opposite side of
the '' '' mark is the direction
you pull out the wiper blade.
Pull out the blade by grabbing
the end of the blade as shown
above illustration.
BLADE
REINFORCEMENT
4. Examine the new wiper blades. If
they have no plastic or metal
reinforcement along the back
edge, remove the metal
reinforcement strips from the old
wiper blade, and install them in
the slots along the edge of the new
blade.
Wiper Blades
5. Install the new blade onto the
blade assembly:
Find two tabs with a ''SET'' and
'' '' mark on the wiper blade
assembly. This is the direction you
install.
Slide the blade onto the assembly
until it is locked by the tabs.
TABS
CONTINUED
369