Main Menu
Table of Contents
Lights
Replacing Rear Bulbs
(in Rear Pillar)
COVERS
1.
Open the tailgate.
Remove the two bolt covers on the
2.
rear pillar by prying on the bottom
edge with a flat-tip screwdriver.
Remove the bolts with a Phillips-
head screwdriver, and remove the
light assembly from the rear pillar.
362
BOLTS
3.
Determine which of the three
bulbs is burned out: brake/
taillight, turn signal or rear side
marker.
4.
Remove the socket by turning it
one-quarter turn counterclockwise.
5.
Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
BULB
SOCKET
6.
Turn on the lights to make sure
the new bulb is working.
7.
Put the socket back into the light
assembly, and turn it clockwise to
lock it in place.
8.
Install the rear light assembly in
the rear pillar. Tighten the two
bolts. Snap the bolt covers into
position.