Wep Security - NETGEAR CG3100 User Manual

In the Security Options section of the
1.
Wireless Settings screen, leave the default
setting or select one of the WPA settings:
WPA-PSK. This setting provides the TKIP
•
encryption type and a pre-shared key
passphrase.
WPA2-PSK. This setting provides the AES
•
encryption type and a pre-shared key
passphrase.
Depending on the WPA settings that you select,
2.
enter the required information.
For WPA-PSK or WPA2-PSK, enter the
pre-shared key, which is a passphrase between 8 and 63 characters. This product comes
with a preconfigured WPA passphrase.
Click Apply to save your settings.
3.
Configure your wireless computers with the same WPA2 or WPA settings as your gateway
4.
so that you will be able to connect.

WEP Security

By default, the gateway is set up to work with WPA and WPA2
Note:
wireless security, both of which are newer than WEP. Typically, the
only reason you might need to set up WEP would be to allow access
to older wireless computers or devices that cannot support WPA.
NETGEAR Wireless Cable Gateway
Wireless Configuration
18