Basic Configuration - NETGEAR CG3100 User Manual

Select WPS Settings and then click Next. The Add WPS Client screen displays.
2.
Any computer or wireless device that will wirelessly connect to the gateway is a client.
After it is added as a client, it will be able to automatically connect to the gateway.
Select the PIN radio button.
3.
Type the PIN that you located in Step 1 in the Enter Client's PIN field, and then click Next.
4.
The WPS LED on the front of the gateway begins to blink.
•
The gateway tries to communicate with the wireless computer or device for 4 minutes.
•
If the Security Option in the Wireless Settings screen was set to Disabled, it is
•
automatically changed to WPA-PSK (including a PSK security password).
When the computer connects to the wireless network, the gateway sends its SSID and
WPA-PSK or WPA2-PSK configuration to that computer.
On the computer that just joined the wireless network, make sure you can connect to the
5.
Internet. You should see the gateway's Internet LED blink, showing that its Internet
connection is in use.

Basic Configuration

Select Configuration > Basic to configure and monitor your network configuration.
Network Configuration. The screeh shows the current network settings on the WAN side of
the gateway. If you are using dynamic IP addressing, this configuration has been assigned by
NETGEAR Wireless Cable Gateway
Wireless Configuration
14