Configuring Wep (Wired Equivalent Privacy) Wireless Security - NETGEAR CG3000D User Manual

Configuring WEP (Wired Equivalent Privacy) Wireless Security

Note: If you use a wireless computer to configure wireless security settings, you will be
disconnected when you click Apply. Reconfigure your wireless computer to match
the new settings, or access the gateway from a wired computer to make further
changes.
To configure WEP data encryption:
1. Log in to the gateway as described in
2. In the main menu, under Setup, select Wireless Settings.
3. In the Wireless Settings screen, depending on the encryption strength that you want, select one
of these options:
• WEP (Wired Equivalent Privacy) 64-bit encryption
• WEP (Wired Equivalent Privacy) 128-bit encryption
Settings for WEP encryption are shown in the following figure (which is the bottom part of the
Wireless Settings screen).
Figure 2-2
4. Select the WEP security encryption from the Authentication drop-down list. Select
Automatic, Open System or Shared Key. The default is Automatic.
Wireless Configuration
Wireless Cable Gateway CG3000D/CG3100D User Manual
"Logging In to Your Gateway" on page
v1.0, September 2009
1-4.
2-7