Extron electronics CrossPoint 300 84 User Manual page 4

Quick Start — CrossPoint 300 Matrix Switchers, cont'd
RGBHV and Audio buttons select/deselect
video and/or audio. The Audio LED blinks to
indicate audio breakaway.
The Audio button and LED are present on
video-only switchers, but have no
function.
Audio also selects the audio level/adjust
mode. See "View, adjust the audio level" at
right.
Create a tie
1. Press and release
the Esc button to
clear any input
LEDs, output
LEDs, or control
LEDs that may be
lit.
2. Press and release the RGBHV and/or Audio
I/O button(s) to select or deselect video and/
or audio as desired.
Lit when selected.
Off when deselected.
RGBHV AUDIO
3. Press and release the
desired input button.
4. Press and release the
desired output button(s).
Output LEDs blink to indicate a potential tie.
3
5. Press and release the Enter button. All input
and output LEDs and the Enter LED go out.
QS-2 CrossPoint 300 Matrix Switchers • Quick Start
Press the Esc button to
clear all selections.
The LED
blinks once.
ESC
I/O
Off when deselected.
Lit when selected.
5
The input LED
lights to indicate
the selection.
4 8 ENTER
Enter LED blinks to
indicate the need to
confirm the change.
Save or recall a preset
1. Save a preset — Press and hold the Preset
button for 2 seconds.
Recall a preset — Press and release the Preset
button.
Preset LED blinks.
Save a
Press and hold.
preset
2 seconds
PRESET
Preset LED lights.
Recall a
Press and release.
preset
PRESET
All input and output buttons with assigned presets light.
The configuration data at assigned preset
locations will be overwritten.
1 2
2. Press and
1
The LED blinks to indicate that this preset
release the
is selected.
desired
input or
output
button.
3. Press and release the Enter button.
View, adjust the audio level
1. Press and hold the
Audio button.
2. Press an input or
output button. See
chapter 3 to read the
displayed value.
7
Output LEDs display the
gain/attenuation.
— or —
Input LEDs display the
output volume level.
4 5 6 7
OUTPUTS
3. Increase and decrease the
gain/attenuation or
volume level by pressing
the Esc ( ) and
View ( ) buttons.
4. Press and release the
Audio button to exit.
PRESET
PRESET
3 4 5
The Enter LED
blinks to indicate
the need to save or
ENTER
recall the preset.
Audio LED blinks.
Hold
2 seconds
AUDIO AUDIO
Press an input button to
adjust gain/attenuation.
— or —
Press an output button
to adjust the output
VIEW ESC
This button This button
decreases increases
the level.
the level.