Extron electronics CrossPoint 300 84 User Manual page 19

Crosspoint 300 series matrix switchers
Hide thumbs Also See for CrossPoint 300 84:
Table of Contents

Advertisement

See figure 2-4 to identify the tip, ring, and sleeve when you are making
connections for the switcher from existing audio cables. A mono audio
connector consists of the tip and sleeve. A stereo audio connector consists of
the tip, ring and sleeve. The ring, tip, and sleeve wires are also shown on the
captive screw audio connector diagrams, figure 2-3 and figure 2-5.
Tip (+)
Sleeve ( )
RCA Connector
Figure 2-4 — Typical audio connectors
The audio level for each input can be individually set via the front panel or
serial port control to ensure that the level on the output does not vary from
input to input. See chapter 3, "Operation", chapter 4, "Programmer's Guide",
and chapter 5, "Matrix Software" for details.
Connections for balanced and unbalanced audio outputs — These 3.5 mm,
4
5-pole captive screw connectors output the selected unamplified, line level
audio. Connect audio devices, such as an audio amplifier or powered
speakers. See figure 2-5 to properly wire an output connector. Use the
supplied tie-wrap to strap the audio cable to the extended tail of the
connector.
Do not tin the wires!
Figure 2-5 — Captive screw connector wiring for audio output
Connect the sleeve to ground (Gnd). Connecting the sleeve to a negative
CAUTION
(-) terminal will damage the audio output circuits.
The length of the exposed (stripped) portion of the copper wires is
CAUTION
important. The ideal length is 3/16" (5 mm). Longer bare wires can
short together. Shorter bare wires are not as secure in the direct insertion
connectors and could be pulled out.
The volume level for each output can be individually set via the front panel or
RS-232/RS-422 control. See chapter 3, "Operation", chapter 4, "Programmer's
Guide", and chapter 5, "Matrix Software" for details.
CrossPoint 300 Matrix Switchers • Installation
Tip (+)
Ring (-)
Sleeve ( )
3.5 mm Stereo Plug Connector
(balanced)
Tip
NO GROUND HERE.
Sleeve(s)
Tip
NO GROUND HERE.
Unbalanced Stereo Output
Tip
Ring
Sleeve(s)
Tip
Ring
Balanced Stereo Output
2-5

Advertisement

Table of Contents
loading

Table of Contents