Sherwood RD-8504 Operating Instructions Manual page 54

RD-8504(G)_ENG_091217:RD-8504(G) 2009-12-21 오
Continued
■When selecting the HD Audio
• When the source components that cannot support the HD audio signal format (such as Dolby Digital Plus, Dolby TrueHD,
DTS-HD High Resolution Audio, DTS-HD Master Audio, etc.) are connected to the HDMI IN of this receiver, some
components may not output any audio signals from its HDMI OUT.
In this case, you should set the HD Audio to Off to play the audio signals other than the HD audio signals. (For details on the
audio signal format, refer to the operating instructions of the source component.)
On : To play the audio signals (including the HD audio signals).
↕
Off : To play the audio signals other than the HD audio signals.
When selecting the Re-Name
• You can give names to the input sources other than tuner.
• Up to 8 characters can be entered for each name.
1.
Press the CURSOR UP/DOWN buttons to select the desired input source, then press the CURSOR RIGHT
button to enter the setting menu.
2.
Press the CURSOR UP/DOWN buttons to select the Re-Name, then press the CURSOR RIGHT button to
enter the setting menu.
11:36 페이지 54
Example : When selecting the VIDEO 1 as an input source
54
Cancel VIDEO 1 Finish