Sherwood RD-8504 Operating Instructions Manual page 24

RD-8504(G)_ENG_091217:RD-8504(G) 2009-12-21 오
Continued
■To cancel the surround mode for stereo operation
■2CH downmix mode
• This mode allows the multi-channel signals encoded in DTS or Dolby Digital format, etc. to be mixed down into 2 front
channels and to be reproduced through only two front speakers or through headphones.
• When the SPEAKER button is set to off to listen with headphones while playing the multi-channel digital signals from DTS or
Dolby Digital sources, etc., it will enter the 2CH downmix mode automatically.
Adjusting each channel level with test tone
• The volume level of each channel can be adjusted easily with the test tone function.
■
Note : When the SPEAKER button is set to off, the test tone function does not work.
1.
Enter the test tone mode.
2.
At each channel, adjust the level as desired until the sound level of each speaker is heard to be equally loud.
3.
Cancel the test tone function.
11:36 페이지 24
• Depending on the signal format which is being input,
either the stereo mode or the 2CH downmix mode is
selected.
• To cancel either the stereo mode or the 2CH
downmix mode, select the surround mode with using
the MULTI CONTROL knob on the front panel or the
SURROUND MODE UP/DOWN (〉 /〈) buttons on the
remote control.
• The test tone mode is displayed and will be heard from the
speaker of each channel for 2 seconds as follows:
→ FL → C
Front Left
← SL ( ←
SUB
Subwoofer
• When the speaker setting is "No", the test tone of the
corresponding channel is not available.
• ( ) : Possible depending on whether the surround back
channel is set to "2 Channel" or "1 Channel (Left)".
24
→ →
FR SR
Center Front Right Surround Right
or ( SBL ← SBR) ←
SB )
Surround Left Surround Back Surr.Back Left Surr.Back Right
• You can select the desired channel with
pressing the CONTROL UP/DOWN buttons
or the CURSOR UP/DOWN buttons.