HP 4250 User Manual page 47

Field Name
Enable SNMPv3
User Name
Authentication Key
Privacy Key
Engine ID
SNMP Traps: IP Address
SNMP Traps: Community Name
SNMP Traps: Port
To register for traps, follow these steps:
SNMP Settings Page
Description
Select this to enable SNMPv3. User account information will be saved and
restored during a firmware
User name must be between 2 and 32 characters long.
Must be 32 characters long. Can be numbers 0-9 or characters a-f or A-F.
Can be numbers 0-9 or characters a-f or A-F.
SNMP v3 engine's administratively unique identifier; used solely for
identification, not for addressing.
Type the IP address of where the trap is being sent.
Type a community name for the trap packet. ("Public" is a common
community name.)
Specify the port number. (Most SNMP agents receive traps on port 162)
upgrade.