Precor P10 Operating And Maintaining page 85

Installing the Console
Table 1. P80 internal cable connections
Cable
Ethernet (LAN)
TV in
Power
Data from base unit
Heart rate sensors
Safety key (treadmills
only)
CSAFE
Automatic stop
sensor (treadmills
only)
To simplify installation and maintenance, route and connect
cables 1 through 5 according to the following instructions.
Note: In the illustrations in this section, some cables are
omitted for the sake of clarity.
Connecting the Television Cable
The console's television tuner is mounted inside the console's
back plate. The tuner includes a short cable adapter that
allows the television cable to be connected outside the back
plate.
To connect the television cable:
1.
2. Route the cable counterclockwise around the outside of
Connector Type
Eight-contact modular,
on round black cable
F-type coaxial
Two-contact plug,
polarized and latched
Eight-contact modular,
on flat gray cable
Four-contact strip, keyed
Six-contact strip, keyed
Eight-contact modular,
on flat gray cable
Vertical four-contact
strip, keyed
Pull the cable out through the lower right corner of the
back plate.
the back plate.
Important: In the following step, install the cable using a
torque wrench and torque not to exceed 8 lb-in. If a torque
wrench is not available, install the coaxial cable using a plain
wrench and tighten to "snug +
wrench on the internal nut to help tighten the connection.
Circuit
Connector
Location
turn." You may also use a
¹₄
39