Precor P10 Operating And Maintaining page 77

Assembling the EFX
4. Fully tighten the fasteners using a ⁹₁₆-inch box-end
5. Align the cut-out inside the link arm cap with the link arm
To attach the upright support covers and pivot arm caps:
1.
2. Line up the protrusions on the outer cover with the screw
3. Apply pressure to both covers so that the protrusions fit
4. Secure the upright support covers using two self-tapping
wrench.
Figure 17: Link arm attachment
mounting hole. Apply pressure to the cap until it snaps
into place.
Place one inner and one outer upright support cover
around one of the upright supports, aligning them so that
the arrows on their inside surfaces point toward the front
of the unit.
holes on the inner cover.
firmly into the screw holes.
screws.
Figure 18: Upright support cover attachment (right-hand
cover shown)
31