Precor P10 Operating And Maintaining page 29

Setting Up the Console
Event
Number
31
32
33
37
40
42
43
44
45
50
53
54
55
60
61
62
70
71
72
73
74
75
76
77
78
79
Description of Event
Incorrect Communications event upper board to lower
board
Communication event upper board to lower board
Incorrect communications event lower board to upper
board
E-STOP error (treadmill only)
Lift motion detected
Lift position value out of range
Zero switch not found
Un-commanded lift motion
Lift going in the wrong direction
Too much brake (magnet) current
Cannot read target, cannot find home switch
Target pulses lost during operation
Brake home switch activated unexpectedly
Auto Stop sensor failure (treadmill only)
Auto Stop not present (treadmill only)
Vertical sensor failure (AMT only)
Belt replacement, lower control board not read (AMT
only)
Belt replacement, new lower control board (AMT only)
Belt replacement, lower control board version unknown
(AMT only)
Belt replacement, lower control board record bad (AMT
only)
Belt replacement, lower control board refurbished
console (AMT only)
Belt replacement, refurbished lower control board
(AMT only)
Belt replacement, console stride count is less than lower
control board (AMT only)
Belt replacement, console stride count is greater than
lower control board (AMT only)
Belt replacement warning (AMT only)
Belt replacement required (AMT only)
27