Precor P10 Operating And Maintaining page 68

22
Assembling and Maintaining Elliptical Fitness Crosstrainers: EFX 885 / 835 / 815
2. Thread the cable through the left upright support. Tape it
3. Attach the left upright support to the base frame using
4. Repeat steps 2 through 4 to attach the right upright
5. Using a right-angle ³₁₆" hex wrench, remove the four ¹₄" x
to the top of the upright support to secure it temporarily.
Important: Do not stretch, crimp, or damage the cable.
Cables damaged by improper installation will not be covered
by the Precor Limited Warranty.
Figure 3: Thread cable through upright support
four buttonhead screws, four split washers, and four
⁵₁₆-inch washers. Partially tighten the fasteners.
Figure 4: Attach the upright support to the base frame
support.
³₄" buttonhead screws securing the central plastic base
cover.