Precor P10 Operating And Maintaining page 69

Assembling the EFX
6. Remove the tape at the top of the left upright support.
7. Feed one of the cables you want to install down through
8. Pull the end of the cable upward through the opening just
9. Locate the tabbed end of the modular plug coupler. Snap
10. Slide the quick-disconnect terminal on the grounding lead
the upright support, then along the inside of the foot
support and back through the central frame member. The
following illustration shows the general path of the cable.
Figure 5: EFX cable path
behind the lift motor, as shown in the previous illustration.
this end of the coupler into the square opening in the jack
panel.
of the power cable over the grounding terminal on the
equipment frame.
23