Precor P10 Operating And Maintaining page 76

Console

Hide thumbs Also See for P10:

Table of Contents

Assembling and Maintaining Elliptical Fitness Crosstrainers: EFX 885 / 835 / 815

2. To attach the upper body handlebars, place one split

3. Attach the handlebars to the link arms using two hex

washer and one ⁵₁₆-inch washer on each of six

socket-head cap screws, then insert three of the screws

through each handlebar bracket. Fully tighten the

fasteners using a ¼-inch hex key.

Figure 16: Upper body handlebar attachment detail

Important: In the following step, install the fasteners in the

order presented. The bushing slides inside the link arm. The

heads of the screws remain on the ramp side of the link arm.

head screws, two bushings, and four ³₈-inch washers.

Note: For ease of installation, slide the corresponding foot

pedal to the top of the ramp before attaching each

handlebar.

Table of Contents

Chapters

Table of Contents