Troubleshooting; Maintenance And Storage - Omron BF00 Instruction Manual

7.Troubleshooting

7. Troubleshooting
Problem
Nothing is displayed when the
power switch is pushed.
An error message (Err1 to Err)
is displayed and
measurements cannot be
taken.
The weight values vary widely
for each measurement.
The battery low indicator
appears.
The %Fat value displayed is
abnormally high or low.
Other conditions.

8. Maintenance and Storage

To protect your unit from damage, please observe the following:
• Do not wipe the unit with benzene, gasoline, paint thinner, alcohol, or other volatile
solvents.
• Do not subject the unit to extreme temperatures, humidity, dust, moisture or direct
sunlight.
• Do not subject the unit to strong shocks, vibrations (for example, dropping the unit on
the floor), or uneven surfaces.
• Do not use the unit where it will be exposed to chemicals or corrosive vapors.
Caution!
• Always store the unit where unsupervised young children will not be able to access it.
• Do not disassemble the unit. You may be injured or damage the unit.
• Remove the batteries from this unit when you are not going to use it for a long period of
time (approximately three months or more).
22
Cause
Are the batteries worn out?
Are the batteries correctly
aligned?
Refer to "6. Error Displays" on page 21.
Is the unit placed on a carpet or
other soft flooring?
Is the floor surface is uneven?
The battery power is low.
Refer to "Avoid Taking Measurements Under the Following
Conditions" and "Cases When the Calculated Results May Differ
from Actual Body Fat Percentages" on pages 16 to 17.
Remove the batteries, then reinsert them after waiting for at least
one minute.
Correction
Replace all four "AA" batteries
with new ones.
Insert the batteries correctly.
Place the unit on a hard, level
floor.
Replace all four "AA" batteries
with new ones.