Table of Contents
Advertisement
VC720507MUK Rev1_Instruction Book 09/01/2014 16:55 Page 7
Using in upright steam cleaning mode (continued)
Select the desired steam level by pressing the
steam level select button
light next to your desired level is illuminated:
low steam (19), for use on laminates and wood.
medium steam (18), for use on vinyls or carpets.
high steam (17), for use on ceramics.
Steam will start to be emitted around 30 seconds
after the steam level select button is pressed.
If cleaning carpets, rest the floorhead
the micro-fibre floor cloth
carpet glider
(31)
to make it easier to move the
floorhead across the carpet.
NOTE: The carpet glider is designed to make it
easier to move the floorhead across the carpet
and is intentionally a loose fit on the floorhead.
5
(12)
until the indicator
7
(22)
with
(27)
attached into the
To enable you to more easily see the areas in need
9
of cleaning, you may use the LED lights
in the front of the floorhead (22). Press LED light
button 1
light button 2
required.
Place the floorhead
(22)
on the floor. Hold the
floorhead to the floor with your foot and tilt the
steam cleaner back.
Never hold the steam cleaner continuously in
one place, as excess moisture and heat may
adversely affect some floor surfaces.
If attempting to steam clean a heavily soiled
area on either carpet or hard floor, it may be
necessary to operate the vibrate function. This
will vibrate the floorhead
(22)
dust and dirt. To use this function, press the
vibrate button (14). To stop the vibrate function,
press the vibrate button again.
(13)
to illuminate the area, and press LED
(16)
if additional illumination is
6
8
to help agitate the
(25)
situated
7 7
Advertisement
Table of Contents
