Table of Contents
Advertisement
VC70465MUK Rev2_Instruction Book 25/09/2012 15:00 Page 4
Assembling the handle
Insert the handle
handle tube
(4)
(with the small clip on the
handle below the upper cord storage hook
aligned with the small rectangular hole
towards the top of the tube) until the handle
clicks into place.
If you wish to remove the handle (1), press the
metal clip at the top of the tube and lift out the
handle.
Steam cleaning floors
IMPORTANT: Before use, hardfloors should be thoroughly swept and carpets should be thoroughly dry
vacuumed. However, we recommend that the steam cleaner is not used on:
bare wooden floors or any surfaces where wood is exposed (as it will absorb moisture and may distort).
•
damaged hardfloors or hardfloors with gaps present (as it will absorb moisture and may distort).
•
Also, do not keep the mop in one place for an extended period, because the continual heat may cause
damage to carpets and laminate flooring.
If cleaning hard floors, attach the hard-floor
micro fibre cloth
(18)
on the underside of the floorhead (16). The
hard-floor cloth has white fastening strips
on its upper side to be aligned with the
fastening pads on the floorhead.
4
1
(1)
into the top of the upper
(2)
1
to the fastening pads
(22)
(19)
Insert the lower handle tube
slot
(7)
until it clicks into place.
If you wish to remove the handle
upper
(4)
and lower
(6)
handle tubes) when
emptying the water tank (11), press the handle
release button
(8)
and lift the handle and tubes
out.
If cleaning carpet, place the carpet micro-fibre
cloth
(20)
into the carpet glider
up), then attach the carpet glider to the
underside of the floorhead (16).
The carpet glider is designed make it easier to
move the floorhead across the carpet.
2
(6)
into the handle
(1)
(with the
2
(21)
(either side
Advertisement
Table of Contents
