Table of Contents
Advertisement
70536 rev1 version2
7/9/07
14:42
Page 5
Steam cleaning
G
1
Ensure the safety lock  is off.
Push the lock from the left side to
lock the trigger and push from the
right to release the lock G.
2
Press the steam trigger and steam
will be emitted from the nozzle.
H
Direct the steam at a cloth or into
a bucket or sink until the steam is
emitted evenly.
Warning: At the start, hot
water may be ejected.
Warning: Aim the steam
safely.
I
3
Keep the steam trigger pressed
and direct the steam at the surface
to be cleaned, removing the dirt by
moving the steam jet backwards
and forwards over the area.
4
To stop the steam jet, release the
J
steam trigger.
IMPORTANT: Do not hold the
steam jet concentrated in one
place for too long.
•
To control the steam temperature
and the cleaning power move the
K
handle closer to or further away
from the surface being cleaned.
Steam adjustment
The steam adjustment control ‚
varies the steam output. Turn the
knob fully anti-clockwise for the
maximum amount of steam or
L
clockwise for decreasing amounts
of steam H.
ACCESSORIES
Warning: Unplug the steamer
and allow to cool before
M
fitting or changing
attachments as they become
hot during use.
Attach the desired accessory to
the hose handle ‰. Extension
tubes can be attached to the
handle for extra reach.
1
Push the extension tubes Ë onto
N
the handle connection nozzle as
far as they will go until you hear a
click I.
•
Some tasks may be easier with
only one tube fitted or none at all.
2
To connect the desired accessory
directly to the hose handle, slide
the handle into the accessory head
or tube until it locks in place J.
Floor nozzle
Ì
The floor nozzle is used for the
cleaning of large, washable walls
and floor areas. The floor nozzle
can be used with or without the
cotton towel Ó.
•
Sensitive surfaces, wood, linoleum
etc. should be used with the cloth.
1
Fit the elbow attachment Ï to the
floor nozzle and twist 1 /2 a turn K.
2
Fit the floor nozzle to the extension
tube or handle L.
3
To fit the cloth to the floor nozzle
pull the cloth under the clips on
both sides. Extra cloths can be
ordered through our helpline.
Alternatively any strong,
uncoloured cotton cloths may be
used M.
•
The cleaning power of the cloth
can be optimised by turning and
changing the cleaning cloth
regularly.
•
To clean very dirty areas, move the
cleaning nozzle over the surface
more slowly in order to increase
the cleaning action of the steam.
IMPORTANT: The cleaner is not
suitable for cleaning unsealed
wooden floors, laminates, soft
plastics or wooden furniture. If in
doubt check with the flooring
manufacturer.
Accessory adaptor
1
Push the jet nozzle adaptor Û as
far as it will go onto the connection
nozzle until you hear it click into
place N.
The jet nozzle adaptor can be
2
removed again by pressing the
accessory connection button to
release it.
5 5
Advertisement
Table of Contents
