Table of Contents
Advertisement
VC720503MUK Rev1_Instruction Book 09/08/2013 09:30 Page 6
Sweeping floors
Hold the floorhead
and tilt the steam cleaner back.
Steam cleaning floors
IMPORTANT: Before use, hardfloors should be thoroughly swept and carpets should be thoroughly dry
vacuumed. However, we recommend that the steam cleaner is not used on:
•
bare wooden floors or any surfaces where wood is exposed (as it will absorb moisture and may distort).
•
damaged hardfloors or hardfloors with gaps present (as it will absorb moisture and may distort).
Also, do not keep the steam cleaner in one place for an extended period, because the continual heat
may cause damage to carpets and laminate flooring.
On wood and laminate flooring, do not make the floor overly wet - always set the steam to minimum.
Please disconnect and allow the unit to cool before changing cloths and attachments.
If steam cleaning hard floors, attach the
micro-fibre floor cloth
on the underside of the floorhead (22). The
micro-fibre floor cloth has white fastening strips
(29)
on its upper side to be aligned with the
grips on the floorhead.
6
1
(22)
to the floor with your foot
3
1
(28)
to the cloth grips
(36)
To sweep your floors, use your foot to press the
sweeper on/off button (23).
Move the floorhead backwards and forward
across the floor.
To empty the dust tray (24), remove it by lifting it
up and out of the floorhead
(22)
handle (25). Keep the dust tray horizontal and
take to a bin. Once emptied, replace the dust tray
into the floorhead.
The dust tray may be rinsed with cool water but
must be thoroughly dry before re-fitting.
If cleaning carpet, rest the floorhead
the micro-fibre floor cloth
carpet glider
(30)
to make it easier to move the
floorhead across the carpet.
NOTE: The carpet glider is designed to make it
easier to move the floorhead across the carpet
and is intentionally a loose fit on the floorhead.
2
with the dust tray
2
(22)
with
(28)
attached into the
Advertisement
Table of Contents
