Table of Contents
Advertisement
VC720504MUK Rev1_Instruction Book 07/08/2013 16:28 Page 4
Assembling the appliance
Steam cleaning floors
IMPORTANT: Before use, hardfloors should be thoroughly swept and carpets should be thoroughly dry
vacuumed. However, we recommend that the steam cleaner is not used on:
•
bare wooden floors or any surfaces where wood is exposed (as it will absorb moisture and may distort).
damaged hardfloors or hardfloors with gaps present (as it will absorb moisture and may distort).
•
Also, do not keep the steam cleaner in one place for an extended period, because the continual heat
may cause damage to carpets and laminate flooring.
On wood and laminate flooring, do not make the floor overly wet - always set the steam to minimum.
Please disconnect and allow the unit to cool before changing cloths and attachments.
Switching the product on
Press the collapsible handle release/restore
button (5), then swing the upright handle
upwards until it clicks into place in an upright
position.
4
Slide the steam outlet at the base of the main body
(13)
onto the mating spigot of the floorhead
secure with the floorhead securing screw
provided. A cross-head screwdriver will be required
to tighten the screw.
NOTE: The floorhead securing screw is supplied in a
small plastic bag taped on the inside of the internal
packing sleeve.
1
Rotate the upper cord storage hook
(3)
release the power cord (18).
Secure the power cord in the cord holder
whilst using the cleaner.
Connect the plug to the mains supply. Switch the
3
product on using the on/off button (14).
The low steam level indicator light
to show the product is active.
(23)
and
(21)
2
(4)
to quickly
(2)
(11)
will illuminate
Advertisement
Table of Contents
