Power Connector Cable - HP MINI 110 110 Maintenance And Service Manual

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service cover (see
6. Disconnect the hard drive cable from the system board (see
7. Disconnect the WWAN antenna cables from the WWAN module (see
on page
8. Disconnect the WLAN antenna cables from the WLAN module (see
9. Remove the following components:
a. Keyboard (see
b. Top cover (see
c. Display assembly (see
d. System board (see
Remove the power connector cable:
1. Remove the Phillips PM2.0×4.0 screw that secures the power connector and bracket to the base
enclosure.
2. Remove the power connector bracket .
NOTE:
number 607765-001.
Battery on page
Service cover on page
43).
Keyboard on page
Top cover on page
Display assembly on page
System board on page
The power connector bracket is included in the base enclosure spare part kit, spare part
38).
40).
Hard drive on page
54).
57).
64).
68).
Component replacement procedures
Spare part number
607755-001
41).
WWAN module
WLAN module on page 46).
73