Power Connector Cable - HP HDX 18 Maintenance And Service Manual

Power connector cable

✎
The power connector cable is included in the base enclosure spare part kit, spare part number 496880-001.
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Optical drive (see
b. Hard drive (see
c. TV tuner module (see
d. Memory module (see
e. WLAN module (see
f. Switch cover (see
g. Keyboard cover (see
h. Keyboard (see
i. Speaker assembly (see
j. Display assembly (see
k. Top cover (see
Remove the power connector cable:
1. Remove the Phillips PM2.0×4.0 screw 1 that secures the power connector and bracket to the base enclosure.
2. Remove the power connector bracket 2.
3. Remove the power connector and cable 3.
Reverse this procedure to install the power connector cable.
Removal and replacement procedures
"Battery" on page
"Optical drive" on page
"Hard drive" on page 4-11)
"TV tuner module" on page
"Memory module" on page
"WLAN module" on page
"Switch cover" on page
"Keyboard cover" on page
"Keyboard" on page 4-24)
"Speaker assembly" on page
"Display assembly" on page
"Top cover" on page 4-38)
4-8).
4-9)
4-13)
4-15)
4-16)
4-18)
4-20)
4-30)
4-31)
4–52