Fan/Heat Sink Assembly - HP HDX 18 Maintenance And Service Manual

Fan/heat sink assembly

Description
Fan/heat sink assembly (includes replacement thermal material)
✎
To properly ventilate the computer, allow at least a 7.6-cm (3-inch) clearance on the left side of the computer.
The computer uses an electric fan for ventilation. The fan is controlled by a temperature sensor and is designed
to turn on automatically when high temperature conditions exist. These conditions are affected by high external
temperatures, system power consumption, power management/battery conservation configurations, battery fast
charging, and software requirements. Exhaust air is displaced through the ventilation grill located on the left side
of the computer.
Before removing the fan/heat sink assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Optical drive (see
b. Hard drive (see
c. TV tuner module (see
d. Memory module (see
e. WLAN module (see
f. Switch cover (see
g. Keyboard cover (see
h. Keyboard (see
i. Speaker assembly (see
j. Display assembly (see
k. Top cover (see
l. System board (see
Removal and replacement procedures
"Battery" on page
"Optical drive" on page
"Hard drive" on page 4-11)
"TV tuner module" on page
"Memory module" on page
"WLAN module" on page
"Switch cover" on page
"Keyboard cover" on page
"Keyboard" on page 4-24)
"Speaker assembly" on page
"Display assembly" on page
"Top cover" on page 4-38)
"System board" on page
4-8).
4-9)
4-13)
4-15)
4-16)
4-18)
4-20)
4-30)
4-31)
4-44)
Spare part number
496894-001
4–54