Installing Cards; To Install A 3Com 3C589D Etherlink Iii Pc Card - HP OmniBook 900 Evaluation Manual

must create profiles that disable these drivers when the OmniBook is out
of the dock. To create Windows NT Hardware profiles refer to the next
chapter or the read me in the DOCKING directory on the Recovery CD.

Installing Cards

This section describes how to install the following:

To install a 3Com 3C589D EtherLink III PC Card

Requirements
Resources
These procedures assume that Phoenix CardExecutive is installed and
Note
Windows NT Networking has not been installed.
For more information on installing PC Cards in Windows NT, visit our
web site at www.hp.com/omnbook.
1. Connect the CD-ROM drive to the OmniBook and restart Windows
2. Insert the PC Card.
3. When the PCMCIA Card Not Configured window appears, select
4. Insert the Windows NT Installation CD in the CD-ROM drive, enter
5. Enter the resources listed above and click OK.
6. Click OK to the setup message. (The card has not been activated yet.)
7. If you installed the TCP/IP protocol, you will be asked if you wish to
♦ 3Com 3C589D EtherLink III PC Card.
♦ 3Com 3C575 Fast EtherLink XL CardBus PC Card.
♦ OmniBook 900 with Windows NT 4.0 installed.
3Com 3C589D EtherLink III PC Card.
♦
♦ Windows NT 4.0 CD-ROM.
♦ Interrupt: 11
♦ I/O: 0x1000
♦ Memory 0xD4000
NT 4.0.
Install system provided driver for this card and click OK.
the \i386\ directory and click OK.
use DHCP. Select the appropriate choice for your network.
Using Windows NT 4.0
Installing Cards
6-17