To Install Pc Card Support For Retail Windows 98, First Edition (Omnibook 900); To Enable Infrared Support For Retail Windows 98 - HP OmniBook 900 Evaluation Manual

17. Click Next. Windows will detect the CardBus Controller.
18. Click Yes to keep the existing PCCard.vxd.
19. Click Finish.
20. Click Yes to restart the computer.
To Install PC Card support for retail Windows 98, First Edition
(OmniBook 900)
If you've installed a retail version of Windows 98, you'll need to install
PC Card support. This driver is located on the OmniBook's hard drive or
on the Recovery CD in \OMNIBOOK\DRIVERS\WIN98\PCCARD.
1. Insert the Recovery CD.
2. Select Run from the Start menu.
3. Enter \OMNIBOOK\DRIVERS\WIN98\PCCARD\PCCARDQ.EXE
from the Recovery CD and click OK.
4. Shutdown and restart the OmniBook.

To enable infrared support for retail Windows 98

If you've installed a retail version of Windows 98 and you wish to use
infrared, you'll need to enable infrared support.
1. Reboot the OmniBook.
2. When you see the HP logo, press F2 to enter the BIOS Setup utility.
3. Go to the System Devices menu.
4. Set the Infrared Port to Enabled.
5. Set the Mode to FIR.
6. Set the Base I/O address to either 2F8 IRQ3 or 3F8 IRQ4.
7. If necessary, set the DMA Channel to DMA 3.
8. Set the Parallel Port Mode to EPP.
9. Save and exit the BIOS Setup utility.
10. If prompted, enter C:\WINDOWS\OPTIONS\CABS directory and
click OK.
11. Click Yes to restart the computer.
12. From Control Panel, open Infrared then Options.
13. Check Enable infrared communication and click OK.
Using Windows 98
Installing Retail Windows 98
4-9