Enabling The Snmpv3 Protocol - Axis 5400plus User Manual

Configuration Possibilities
Disabling Protocols
Important:
Checking
SSL/TLS Status
To View a Certificate
To Delete a Certificate

Enabling the SNMPv3 Protocol

112
To further increase security, you must disable protocols that are
considered insecure;
• FTP (also used by AXIS ThinWizard. Note that if FTP is disabled, AXIS
ThinWizard can not function properly.)
• Telnet
• Auto-IP
• DHCP
• BOOTP
• Remote Config (used by AXIS NetPilot)
• SNMP Configuration (also used by AXIS ThinWizard. Note that if SNMP
is disabled, AXIS ThinWizard can not function properly.)
To disable these protocols, go to Admin | Security Settings | Protocol
Settings | Detailed View and mark the check boxes. Click OK to finish.
Only enabled protocols will be visible from this view!
To enable these protocols, select Admin | Network Settings | Detailed
View | TCP/IP Network for FTP, Telnet, AutoIP, DHCP and BOOTP.
Remote Config is enabled via Admin | General Settings | RConfig
Support.
To ensure maximum security, it is highly recommended that you change your Administrator
password after generating a certificate and disabling insecure protocols! This is done from
Admin | General Settings | Change => | General | Root Password.
To check SSL/TLS status, open the print server's Web interface and select
Admin | Network Settings | Detailed View | TCP/IP Network to see if the
HTTPS Enabled parameter is set to Yes or No.
To view a Certificate, open the print server's Web interface, select Admin
| Security Settings and click View next to the Certificate.
To delete a Certificate, open the print server's Web interface, select Admin
| Security Settings and click Delete next to the Certificate.
Invoke the print server's Web interface to enable the SNMPv3 protocol.
AXIS 5400+ / AXIS 5600+ User's Manual