Enabling The Snmpv3 Protocol - Axis 27981R1 User Manual

Configuration Possibilities
Important:
Checking
SSL/TLS Status
To View a Certificate
To Delete a Certificate

Enabling the SNMPv3 Protocol

108
To enable these protocols, select Admin | Network Settings | Detailed
View | TCP/IP Network for FTP, Telnet, AutoIP, DHCP and BOOTP.
Remote Config is enabled via Admin | General Settings | RConfig
Support.
To ensure maximum security, it is highly recommended that you change your Administrator
password after generating a certificate and disabling insecure protocols! This is done from
Admin | General Settings | Change => | General | Root Password.
To check SSL/TLS status, open the print server's Web interface and select
Admin | Network Settings | Detailed View | TCP/IP Network to see if the
HTTPS Enabled parameter is set to Yes or No.
To view a Certificate, open the print server's Web interface, select Admin
| Security Settings | HTTPS and click View next to the Certificate.
To delete a Certificate, open the print server's Web interface, select Admin
| Security Settings | HTTPS and click Delete next to the Certificate.
Invoke the print server's Web interface to enable the SNMPv3 protocol.
1. Select Admin | Network Settings | Detailed View | TCP/IP Network and
ensure that HTTPS Enabled is set to yes to guarantee a secure
configuration.
Note: You must have a valid certificate loaded to be able to enable HTTPS.
See "Enabling SSL via the Web Interface" on page 106.
AXIS 5400+ / AXIS 5600+ User's Manual