Table of Contents
Advertisement
TD-W8960N
2.
Enter a unique name for Group.
3.
Select the Interface which you want to use from the drop-down list.
Note:
If you like to automatically add LAN clients to a WAN Interface in the new group add the DHCP
vendor ID string. By configuring a DHCP vendor ID string any DHCP client request with the
specified vendor ID (DHCP option 60) will be denied an IP address from the local DHCP server.
4.
Select interfaces from the available interface list and add it to the grouped interface list using
the arrow buttons to create the required mapping of the ports.
Note:
These clients may obtain public IP addresses.
5.
Click Save/Apply to make the entry effective immediately.
Note:
If a vendor ID is configured for a specific client device, please REBOOT the client device attached
to the modem to allow it to obtain an appropriate IP address.
4.4.15 IPSec
Choose "Advanced Setup" "IPSec", you can Add/Remove or Enable/Disable the IPSec tunnel
connections on the screen as shown in Figure 4-62.
This section will guide you to configure a VPN tunnel between two TD-W8960Ns. The topology is
as follows.
300Mbps Wireless N ADSL2+ Modem Router User Guide
Figure 4-62
53
Advertisement
Table of Contents
