Table of Contents
Advertisement
message in the Status Buffer is the only indication that an anony-
mous call has been rejected.
Incoming Voice Call Rejection List
Contains ten numbers that represent the Call Rejection List. This
list is used when the Enable Call Reject List option is checked.
When the Express 3000 SP detects an incoming Voice or Audio
call, the telephone number of the caller is compared to the num-
bers in this list. If a match is found, the call is rejected.
Generally, the format for the number is one seven-digit number.
If calls are not being rejected while the option is enabled and a
number is programmed, check the Status Buffer for the number of
the caller. The number of the caller should match exactly with the
number in the Call Rejection List.
Advanced Tab
Contains advanced instructions for the Express 3000 SP.
V120 Lower Layer Compatibility
Sends a low-level compatibility information element as part of the
setup message.
Connect Timeout
Sets the length of time that the Express 3000 SP waits for the far-
end unit to answer an outgoing call.
Inactivity Timer
Defines the amount of time (in minutes) the Express 3000 SP re-
mains idle before automatically disconnecting the current data
call. A value of 0 indicates the Inactivity Timer is off.
Remote Password
Accepts the six digit numeric password for the remote unit called.
Valid characters are 0 through 9. Alphabetic characters are not ac-
cepted.
Test Timeout
Defines the amount of time (in minutes) the Express 3000 SP tests
a remote unit.
61203153L3-20
Chapter 3. Using the Express Configuration Program
Express 3000 SP User Manual
3-15
Advertisement
Table of Contents
