ADTRAN Express 3000 SP User Manual page 86

Appendix A. AT Commands and S-Registers
S-Registers List
Function
Command
Conference/
S37
Call Waiting
Bond TXINIT
S40
Bond TXFA
S41
Bond TXADD
S42
Bond TXDEQ
S43
Bond TANULL
S44
Bond TCID
S45
Switch Type
S52
A-12
(Continued)
Flash-hook button defaults to:
0=Call waiting
1=Call conferencing
Specifies the number of seconds the originating endpoint
attempts to detect the Async BONDING negotiation
pattern from the answering endpoint before deciding the
Async BONDING call has failed.
0 to 255, 10 sec is default.
Specifies the number of seconds both endpoints attempt
to detect the async BONDING frame pattern when a call
is connected before deciding the async BONDING call has
failed. When operating with other manufacturer's async
BONDING equipment, it may be necessary to lengthen
this timer so that it matches TXADD01.
0 to 255, 10 sec is default.
The number of seconds both endpoints wait for the
additional call to be connected at the end of negotiation
before deciding the async BONDING call has failed.
When dialing overseas it may be necessary to lengthen
this timer to allow for slower call routing.
0 to 255, 50 sec is default
The number of seconds both endpoints attempt to
equalize the network delay between the bearer channels
before deciding the Async BONDING call has failed.
0 to 255, 50 sec is default
The number of seconds the answering endpoint attempts
to detect the Async BONDING negotiation pattern from
the originating endpoint before aborting to clear channel
mode. It may be necessary to shorten this timer if the DTE
equipment connected to the Express 3000 SP also has
timer constraints for completing non-BONDING
parameter negotiation.
0 to 255, 10 sec is default
The number of seconds both endpoints attempt to
negotiate agreeable values for bearer channels and
channel capacities before deciding the async BONDING
call has failed.
0 to 255, 5 sec is default
Selects the network switch type for dial service.
4=EuroISDN
Express 3000 SP User Manual
Features
61203153L3-20