Internal Hold Mode When Making A Call To Several Users (Isdn/Voip); Configuring An Internal Subscriber Without A Send Connection - Gigaset DX800A User Manual

Description of new and updated functions
Internal Hold Mode when making a call to several users (ISDN/
VoIP)
Your ISDN/VoIP connection offers you two telephone lines that you can use at the
same time. For this reason you have the following two options to hold an external
participant during an external consultation call or during call swapping:
u
Hold connection externally: The call is put on hold in the telephone exchange.
Therefore your second ISDN/VoIP line can be used by another party.
u
Hold connection internally: The call is put on hold in your base station. In this
case both ISDN lines or both VoIP lines are occupied. If the second ISDN/VoIP line
is in use by another party, an external consultation call or accepting a waiting
call is not possible.
To activate/deactivate the internal hold mode, select
¢
v Ï Settings
By factory default, the Internal Hold Mode is deactivated, i.e. external calls are held
on the telephon exchange (central office of the net provider).
If the function Internal Hold Mode is activated, you cannot connect the two
participants with one another (no call transfer).

Configuring an internal subscriber without a send connection

This section extends the section „Configuring the system settings- Assigning send and receive
connections to internal parties - Assigning a send connection" in the user guide for your
Gigaset phone.
You can configure your phone or each of the registered handsets so that you can-
not make external calls. You can only make calls to internal subscribers.
¢
Ï Settings
v
~
A list of the internal parties (base, handsets, device connected to the FAX port INT8
– where applicable) is displayed.
q
r
§Save
Please note
If you select No outgoing calls, all outgoing calls, calls to the network mailbox
and sending of SMS, E-Mail or fax from this internal party is blocked.
If the internal subscriber tries to make an external call, to send an SMS and so on
the message Not possible is displayed.
8
¢
Telephony
Please note
¢
Telephony
§OK§
Select and press
Enter the system PIN if necessary and press
Select the internal party that should not be allowed to set up external
calls and press the display key
Select No outgoing calls to block all outgoing calls from this internal
party.
Press the display key to save the changes.
¢
Internal Hold Mode (³= On)
¢
Send Connections
.
§OK§
.
§OK§
.