Supplements To „Defining Dialling Plans; Downgrading The Firmware - Gigaset DX800A User Manual

All in one phone new and updated functions

Hide thumbs Also See for DX800A:

Table of Contents

Supplements to „Defining dialling plans"

This section extends the „Telephony – Dialling Plans - Defining dialling plans – cost control" in

the user guide for the Web configurator.

Blocking numbers

You can define numbers that are not allowed to be dialled at the base station as well

as at any registered handset.

You define such dialling plans as follows:

Phone Number

Enter the number or the first digits of the phone number which should not be

dialled (max. 15 digits).

Connection

Select Block from the list.

Click on the Add button. The dialling plan is activated immediately.

If you try to dial the number, Not possible is displayed.

The option „Use Area Codes"

When defining a dialling plan you can establish that for each call via VoIP the local

area code shall precede. For that activate the option Use Area Codes correspond-

ing to your dialling plan

This section extends the section „Management – Firmware Update: Updating the base's

firmware" in the user guide for the Web configurator.

You can reload the firmware version that was loaded before the last update on the

phone.

Open the Settings

Select the Downgrade Firmware button. The text above this button shows the

version of the firmware that will be reloaded.

In the following dialog box, click the OK button to confirm the prompt.

The firmware is reloaded to the phone. The new firmware is overwritten. Your con-

nection to the Web configurator is terminated, and the base is rebooted.

This process can take up to 3 minutes.

Description of new and updated functions

Management

Firmware Update Web page.

Table of Contents