Remote Control; Battery Installation - Dimplex DF3215 Owner's Manual

Operation
This odor is a normal condition
caused by the initial heating of
internal heater parts and will
not occur again.
!
NOTE: When the On/Off
switch is in the Flame and
Flame & Heat positions, the
fireplace unit will not operate
with the remote control.
* Not applicable on DF3215NH model
fireplaces. Flame only function on
DF3215NH
Resetting The Temperature
Cutoff Switch *
Should the heater overheat, an
automatic switch will turn the
heater off and it will not come
back on without being reset. The
temperature cutoff switch can be
reset by unplugging the unit, wait-
ing 5 minutes and plugging the
Figure 4
Child Lock
10
Batteries
unit back in.
CAUTION: If you need to
continuously reset the heater,
unplug the unit and call Dim-
plex North America Limited at
1-888-346-7539 for technical
support.

Remote Control

The remote control has a range of
approximately 50 ft. (15.25m). It
does not have to be pointed at the
fireplace and can pass through
most obstacles (including walls).
It is supplied with 243 indepen-
dent frequencies to prevent inter-
ference with other units.

Battery Installation

1. Depress tab on the battery
cover on the back of the
remote control and remove
battery cover (Figure 4).
2. Install two (2) AAA batter-
ies into the remote control
(included).
3. Ensure child lock is in the "un-
locked" position.
4. Replace the battery cover.
!
NOTE: When the
symbol is present on the remote
control it is recommended to
replace the batteries promptly,
to maintain full functionality of
www.dimplex.com