Connecting The Storage Tray Cables - HP B132L+ Owner's Manual

Changing Your Workstation's Hardware Configuration
Replacing the Battery
12 Reconnect the floppy, SE SCSI, power, CD-ROM audio, and FW SCSI cables as
Storage Tray
Power
Figure 62
13 Follow the instructions in Replacing the Main Tray Assembly on page 112.
160
shown in Figure 62.
When connecting the floppy cable to the system board, use the following proce-
dure:
a Lift the locking ring on the connector to the up, or unlocked, position.
b While holding the locking ring in the unlocked position, insert the cable into
the connector with the locking ring.
c Press down on the locking ring evenly on both ends until it snaps into the
down, or locked, position.
FWSCSI
SESCSI
CD Audio
Floppy Connector

Connecting the Storage Tray Cables