Displaying and Setting Paths
A path is the hardware address of a device that is attached to the I/O system
of your workstation. The path command sets the system paths shown in
Table 28.
The path command sets and displays the hardware address of a specified
device attached to the I/O bus of your workstation.
Table 28
System Paths
primary or pri
alternate or alt
console or con
keyboard or key
To display the current settings for the system paths, type the following at the
prompt:
Path Type
Your workstation's default boot device (usually the root disk)
Your workstation's alternate boot device (usually a DDS-format
tape device)
Your workstation's primary display device
Your workstation's primary ASCII input device
Main Menu: Enter command >
The Boot Console Interface
Displaying and Setting Paths
Device
path
205