Scsi Bus Differences - HP B132L+ Owner's Manual

SCSI Bus Differences

A Small Computer Systems Interface (SCSI) bus is an IEEE standard bus for
connecting your workstation to internal and external SCSI devices running
at different speeds, singly or in combination. Examples of these SCSI
devices are 4-mm DDS-format tape drives, CD-ROM drives, and Winches-
ter hard disk drives.
There are three types of SCSI buses available with this workstation - a nar-
row single-ended SCSI (NSE SCSI) bus, and a fast, wide differential SCSI
(FWD SCSI) bus or an ultra, wide, single-ended SCSI bus. Table 17 shows
the specification differences between these SCSI buses, and Table 18 shows
the SCSI addresses, ID numbers, and arbitration priorities for each.
CAUTION: Do not mix single-ended, fast, wide and ultra, wide-SE SCSI devices on any one bus
type. Doing this will cause a system failure.
Table 17

SCSI Bus Differences

Transfer Rate
Single-Ended
Up to 5 Mbytes
per second
Fast, Wide
Up to 20 Mbytes
per second
Ultra, Wide-SE
Up to 40 Mbytes
per second
* Address 7 is reserved for host controller use on both buses.
** Only 2 external devices allowed (total of 4 devices).
Data Bus Maximum
Width Addresses*
8 bits 8
16 bits 16
16 bits 16**
Device
Maximum
Physical
Cable Length
Location
6.0 meters Internal and
(19.6 feet) external
25 meters Internal
(82 feet) and
external
Internal
and
2.0 meters
external
(6.56 feet)
SCSI Connections
SCSI Bus Differences
Controller
Embedded
or Optional
Embedded
Optional
Embedded
173