Changing Your Workstation's Hardware Configuration
Installing Storage Devices
2 Disconnect the power, SCSI and CD Audio cables from the system board and the
3 Remove SCSI terminators from rear panel SCSI connectors (if necessary).
4 Remove the storage tray retaining screw, as shown in Figure 25.
Storage Tray
Power
Locking Ring
Figure 25
Disconnecting the Storage Tray Assembly
118
backplane, as shown in Figure 25.
When disconnecting the floppy cable use the following procedure:
a Lift the locking ring on the connector to the up, or unlocked position.
b While holding the locking ring in the unlocked position, pull the cable out of
the connector.
FWSCSI
SESCSI
CD Audio
Floppy Connector
Rear Panel SCSI Connectors
Retaining Screw