Hp E1366A/E1367A Rf Multiplexer Error Messages - HP E1366A User Manual

HP E1366A/E1367A RF Multiplexer Error
No. Title
-211 Trigger ignored
-213 Init Ignored
-224 Illegal parameter value
1500 External trigger source
already allocated
2000 Invalid card number
2001 Invalid channel number
2006 Command not supported
on this card
2008 Scan list not initialized
2009 Too many channels in
channel list
2012 Invalid Channel Range
2600 Function not supported
on this card
2601 Channel list required
Appendix C
The table below lists the error messages associated with the multiplexer
modules programmed by SCPI. See the appropriate mainframe manual for
a complete list of error messages.
Potential Cause(s)
Trigger received when scan not enabled. Trigger received after scan complete.
Trigger too fast.
Attempting to execute an INIT command when a scan is already in progress.
Attempting to execute a command with a parameter not applicable to the command.
Assigning an external trigger source to a switchbox when the trigger source has
already been assigned to another switchbox.
Addressing a module (card) in a switchbox that is not part of the switchbox.
Attempting to address a channel of a module in a switchbox that is not supported by
the module (e.g., channel 99 of a multiplexer module).
Sending a command to a module (card) in a switchbox that is unsupported by the
module.
Executing a scan without the INIT command.
Attempting to address more channels than available in the switchbox.
Invalid channel(s) specified in SCAN <
scanning when no valid channel l t is defined.
Sending a command to a module (card) in a switchbox that is not supported by the
module or switchbox.
Sending a command requiring a channel list without the channel list.

HP E1366A/E1367A RF Multiplexer Error Messages

Appendix C
Messages
channel_list > command. Attempting to begin
69