[Route:]; Close - HP E1366A User Manual

[ROUTe:]

Subsystem Syntax

CLOSe

Parameters
Comments
Example
48 HP E1366A/E1367A RF Multiplexers Command Reference
The subsystem controls switching and scanning operations for RF
ROUTe
multiplexer modules in a switchbox.
[ROUTe:]
channel_list
CLOSe <
channel_list
CLOSe? <
channel_list
OPEN <
OPEN? < channel_list
SCAN < channel_list
:MODE NONE | VOLT | RES | FRES
:MODE?
[ROUTe:]CLOSe < channel_list
specified by channel_list. The channel_list has the form (@ccnn) where
cc = card number (01-99) and nn = channel number (00-03 and 10-13).
Parameter Name
<channel_list>
Closing Channels: To close:
a single channel, use
–
multiple channels, use
–
sequential channels, use
–
groups of sequential channels, use
–
[ROUTe:]CLOSe (@ccnn:ccnn,ccnn:ccnn)
or any combination.
–
Closure order for multiple channels with a single command is not
guaranteed.
Related Commands:
*RST Condition: All channels open.
Closing Multiplexer Channels
This example closes channels 100 and 213 of a two-module switchbox (card
numbers 01 and 02).
CLOS (@100,213)
>
>
>
>
>
> closes the RF multiplexer channels
Parameter Type
numeric
[ROUTe:]CLOSe (@ccnn)
[ROUTe:]CLOSe (@ccnn,ccnn)
[ROUTe:]CLOSe (@ccnn:ccnn)
[ROUTe:]OPEN , [ROUTe:]CLOSe?
! Close channels 100 and 213.
100 closes channel 00 of card #1;
213 closes channel 13 of card #2
Range of Values
cc00-cc03, cc10-cc13
Chapter 5