Status; Operation[:Event]; Operation:enable - HP E1366A User Manual

STATus

Subsystem Syntax

:OPERation[:EVENt]?

Comments
Example

:OPERation:ENABle

Parameters
Comments
Example
Chapter 5
The subsystem reports the bit values of a Standard Operation
STATus
Status register. It enables the Status register to set a bit after a bit is set to 1
by the Standard Operation register.
STATus
:OPERation
[:EVENt]?
:ENABle < number
STATus:OPERation[:EVENt]?
register (only bit 8 is used by the multiplexer modules).
Setting Bit 8 of the Operation Status Register: Bit 8 (Scan
Complete) is set to 1 after a scanning cycle completes. Bit 8 returns
0 after sending the
Returned Data after sending the
Command: The command returns +256 if bit 8 of the Operation
Status register is set to 1. The command returns +0 if bit 8 of the
Operation Status register is set to 0.
Related Commands:
Reading the Operation Status Register After a Scanning Cycle
STAT:OPER?
STATus:OPERation:ENABle <
register to set a bit in the Status register. For RF multiplexer modules,
setting bit 8 in the Operation Status register to 1 sets bit 7 in the Status
register to 1.
Parameter Name
<number>
Setting Bit 7 of the Status Register:
STATus:OPERation:ENABle 256
after bit 8 of the Operation Status register is set to 1.
Related Commands:
Enabling Status Register Bit 7
STAT:OPER:ENAB 256
HP E1366A/E1367A RF Multiplexers Command Reference
>
returns the bit value of the Operation Status
STATus:OPERation[:EVENt]?
STATus:OPERation[:EVENt]?
[ROUTe:]SCAN
! Returns the bit values of the
Standard Operation Status
register. Returns +256 if bit 8 is
set to 1 or returns +0 if bit 8 is set
to 0.
number > enables the Operation Status
Parameter Type
numeric
sets bit 7 of the Status register to 1
[ROUTe:]SCAN
! Enables bit 7 of Status register
command.
Range of Values
1-32767
53