Table of Contents
Advertisement
Table 3-2
Operating the Library
Setting and Viewing SCSI IDs
Setting SCSI IDs
1 2
ADMIN *
A SCSI ID is required for the robotics controller and each drive. The default IDs are
shown in Table 3-1 on page 3-11.
The following configuration choices are available:
SCSI Address Configuration Options
Number of
Drives
1
13 addresses are available on bus 1. (Drive 1 uses one address
and the library controller uses 1 address.)
2
If buses 1 and 2 are connected to separate host SCSI cards:
•
•
If buses 1 and 2 are daisy-chained:
•
To change the current SCSI address settings:
1. Verify that the drive status displays (if not, press
2. Press
until ADMIN * displays, then press
NEXT
3. Enter the three-part numerical password (see "Entering the Administration
Menu Password" on page 3-9).
4. Press
until SCSI IDs * displays, then press
NEXT
5. SET IDs * displays. Press
LIB BUS # ID # or DRV # BUS # ID # displays. LIB BUS # ID # stands for the
current SCSI ID of the robotics controller. DRV # BUS # ID # is the current
SCSI ID setting for the drive number and its associated bus #.
6. Press
until the setting to change displays, then press
NEXT
3-12
SCSI IDs *
SET IDs *
SCSI Bus Addresses Available
13 addresses are available on bus 1 for other devices.
14 addresses are available on bus 2 for other devices.
12 addresses are available on the bus for other devices.
.
ENTER
until it does).
CANCEL
.
ENTER
.
ENTER
.
ENTER
Advertisement
Table of Contents
