Setting The Scsi Id - HP StorageWorks DLT80 Reference Manual

Setting the SCSI ID

Before beginning the installation process, the SCSI ID must be set. Each SCSI
device on the same SCSI bus must have a unique SCSI ID. Use the jumper block
located on the left side of the tape drive (see
Note:
Figure 3: SCSI ID and Library Controller jumper blocks on the left side
1
2
3
Note:
installed on it.
DLT80 Tape Drive Reference Guide
SCSI ID 7 is reserved for the SCSI controller.
1 2 3 4 5
Remote ID present
Reserved
SCSI Bit 2
Caution: Do not change the settings on the Library Controller block.
If a SCSI ID other than the default is used, the Remote ID pin must have a jumper
Figure
6
4
5
6
Installing an Internal DLT80 Tape Drive
3). The default SCSI ID is 6.
SCSI Bit 1
SCSI Bit 0
Library Controller block
21