Setting A New Administration Menu Password - HP SureStore 4115w User Manual

NOTE
NOTE
Operating the Library

Setting a New Administration Menu Password

Setting a New Administration Menu Password

1 2 ADMIN *
Change the password to so that only authorized persons can access the library and
change operation settings. Do not forget the password. Only a service representative
can reset the password to the factory setting.
To set a new password:
1. Follow the steps on "Entering the Administration Menu Password" on page 3-9
to enter the existing password.
2. Press until CONFIG * displays, then press
NEXT
3. Press or
NEXT PREV
4. NEW 000-000-000 displays, and the first set of zeros flashes.
Press or
NEXT PREV
of the password, then press
5. The second set of zeros flashes.
Press or
NEXT PREV
part of the password, then press
6. The last set of zeros flashes.
Press or
NEXT PREV
of the password, then press
7. PASSWORD CHANGED displays. Press
status ("ready" state).
Save the new password to flash ROM by power cycling the library, which allows the
password to be recovered if the library is powered off for more than ten days.
Do not switch off power to the library until the SCSI bus is inactive. Removing
power from a SCSI peripheral when the bus is active can result in data loss and/or
indeterminate bus states. If the library is connected to a LAN, check with the system
administrator before shutting off power to the library.
3-10
CONFIG * NEW PASSWORD
until NEW PASSWORD displays, then press
to display the new numbers you wish to assign the first part
.
ENTER
to display the new numbers you wish to assign the second
.
ENTER
to display the new numbers you wish to assign the third part
.
ENTER
CANCEL
.
ENTER
.
ENTER
three times to return to the drive