Troubleshooting; Chapter 7 Troubleshooting; Checking The Leds; Normal Mode Led Indications - Cisco Aironet 1300 Series Hardware Installation Manual

Checking the LEDs

Checking the LEDs

If your access point/bridge is not associating with a remote bridge or access point, check the four LEDs
on the back panel. You can use them to quickly assess the unit's status. For information on using the
LEDs during the installation and alignment of the access point/bridge antenna, refer to the
section on page
Figure 7-1
Figure 7-1
R
S

Normal Mode LED Indications

During access point/bridge operation the LEDs provide status information as shown in
Table 7-1 LED Indications
Ethernet Status
LED LED
Off —
Blinking —
green
Blinking —
amber
amber —
Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide
7-2
3-5.
shows the access point/bridge LEDs.
LEDs
R S
I
Radio LED
Status LED
Radio Install
LED LED
— —
— —
— —
— —
E
E
Ethernet LED
I Install LED
Meaning
Ethernet link is down or disabled.
Transmitting and receiving Ethernet packets.
Transmitting and receiving Ethernet errors.
Firmware error—disconnect and reconnect the power injector power
jack. If the problem continues, contact technical support for
assistance.
Chapter 7

Troubleshooting

"LEDs"
Table 7-1.
OL-5048-02