Cisco Aironet 1300 Series Hardware Installation Manual page 46

LEDs
The Install LED provides bridge association status during installation mode as shown in
Table 3-2
Install LED
Off
Amber blinking
Amber
Green blinking
Green
Red
1. Preconfigured bridges search indefinitely.
2. Disconnect power to the power injector, wait approximately 1 minute, and reconnect power. If error
continues, contact technical support.
Use the Install LED to determine when the bridge successfully associates with a remote bridge and to
verify its mode of operation. After association, the other three LEDs indicate signal strength.
The startup and association sequence depends on the access point/bridge configuration, which can be
one of the following types:
Default—The access point/bridge attempts to associate with a root bridge for 60 seconds. If it does
•
not associate with a root bridge, it attempts to associate with a non-root bridge.
Preconfigured bridge mode—The unit attempts to associate with a remote bridge in the configured
•
mode, either root or non-root. Because there are no timeouts, it is easier to align the antenna.
Preconfigured access point or workgroup bridge modes—the bridge Install LED does not operate.
•
Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide
3-6
Install LED Status
Status
Self test
Non-root, searching
Non-root, associated
Root, searching
Root, associated
Error
Chapter 3
Bridge State
Startup.
Not associated (non-root mode). The
access point/bridge attempts to associate
with a root bridge for 60 seconds
Associated (non-root mode).
Not associated (root mode). The access
point/bridge attempts to associate with a
non-root bridge indefinitely.
Associated (root mode).
Overvoltage or overcurrent error
Mounting and Alignment Overview
Table 3-2.
1
.
2
OL-5048-02