Cisco Aironet 1300 Series Hardware Installation Manual page 60

Assigning Basic Settings
Click Express Setup. The Express Setup page displays.
Step 4
Figure 5-2
Enter the configuration settings you obtained from your system administrator. The configurable settings
Step 5
include:
System Name or Host Name—The system name or host name, while not an essential setting, helps
•
identify the access point/bridge on your network. The name appears in the titles of the management
system pages.
Configuration Server Protocol—Click the button that matches the network's method of IP address
•
assignment.
–
Note
–
IP Address—Use this setting to assign or change the access point/bridge's IP address. If DHCP is
•
enabled for your network, leave this field blank.
Note
Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide
5-6
Express Setup Page
DHCP—IP addresses are automatically assigned by your network's DHCP server.
When DHCP is enabled, the IP Address, Subnet Mask, and Default Gateway fields indicate
Negotiated by DHCP.
Static IP—The access point/bridge uses a static IP address that you enter in the IP address field.
If the access point/bridge's IP address changes while you are configuring the access point/bridge
using the web-browser interface or a Telnet session over the wired LAN, you lose your
connection to the access point/bridge. If you lose your connection, reconnect to the access
point/bridge using its new IP address.
Chapter 5 Configuring the Access Point/Bridge for the First Time
Figure 5-2 shows the Express Setup page.
OL-5048-02