Changing The Command History Buffer Size; Recalling Commands; Disabling The Command History Feature - Cisco Aironet 1300 Series Hardware Installation Manual

Chapter 6 Using the Command-Line Interface

Changing the Command History Buffer Size

By default, the access point/bridge records ten command lines in its history buffer. Beginning in
privileged EXEC mode, enter this command to change the number of command lines that the access
point/bridge records during the current terminal session:
br# terminal history
The range is from 0 to 256.
Beginning in line configuration mode, enter this command to configure the number of command lines
the access point/bridge records for all sessions on a particular line:
br(config-line)# history
The range is from 0 to 256.

Recalling Commands

To recall commands from the history buffer, perform one of the actions listed in
Table 6-4 Recalling Commands
Action
Press Ctrl-P or the up arrow key.
Press Ctrl-N or the down arrow key.
show history
1. The arrow keys function only on ANSI-compatible terminals such as VT100s.

Disabling the Command History Feature

The command history feature is automatically enabled.
To disable the feature during the current terminal session, enter the terminal no history privileged
EXEC command.
To disable command history for the line, enter the no history line configuration command.
OL-5048-02
[
size number-of-lines
[
size number-of-lines
Result
1
Recalls commands in the history buffer, beginning with the most recent command.
Repeat the key sequence to recall successively older commands.
1
Returns to more recent commands in the history buffer after recalling commands
with Ctrl-P or the up arrow key. Repeats the key sequence to recall successively
more recent commands.
While in privileged EXEC mode, lists the last several commands that you just
entered. The number of commands that are displayed is determined by the setting
of the terminal history global configuration command and history line
configuration command.
Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide
]
]
Using Command History
Table 6-4:
6-7